Engine adapter plate and a NEW 14 INCH flywheel

THE 360 AND OR DT 360 WILL FIT INTO THE 06 AND 56 SERIES TRACTORS WITHOUT ANY NEED TO EXTEND HOOD OR FRAME RAILS
MAKES A GREAT REPOWER AS THE ENGINES ARE READILY AVAILABLE FROM TRUCK AND SCHOOL BUS APPLICATIONS!!

THE 400 SERIES INSTALLED IN THIS APPLICATION ALMOST ALWAYS REQUIRES 4 TO 6 INCHES  INCHES OF FRAME RAIL AND HOOD EXTENSIONS
BUT WHAT A WAY TO MAKE SOME POWER!!

 Modified plate AND with a new 14 inch flywheel, set up to use stock IH clutch's OR HYDRO FLEX PLATES
Uses same 14 inch clutch parts as a 1066 OR 1456 and many others.
PICTURE OF THE NEW FLYWHEEL WILL BE  POSTED.
WE CAN PRICE THE ENGINE PLATE SEPARATELY !!

 WE HAVE ALSO AN ALL STEEL FLYWHEEL AND TRACTOR PULLING CLUTCH ASSEMBLY AVAILABLE FOR AN ADDITIONAL COST
IS ABLE TO RUN HIGH RPMS (SFI) AND FEATURES DOUBLE OR TRIPLE DISC ABILITY.
WELL BUILT AND UNMATCHED IN PRICE AND VALUE
SEE OUR OTHER LISTINGS HERE!!

ALL ORIGINAL TA ADJUSTMENTS AND CLUTCH CONTROLS CAN BE RETAINED.
This means the CLUTCH parts are available over the counter at your dealer or at any number of aftermarket parts yards and clutch rebuilders.

IT ALSO MEANS OUR HIGH PERFORMANCE TA'S AND  CLUTCHES
 FOR THESE MODEL TRACTORS ARE USABLE AS WELL!!

You are in most all cases able to retain your sheetmetal (hoods etc) in its original position without modification.

THIS PLATE WILL BOLT ONTO AN M , SM. 400, 450 560 660 AND POSSIBLY SOME OTHERS WITH THE SAME
 BELL HOUSING  BOLT PATTERN AS THE 806 ETC.
 WE NOW HAVE A 12 INCH  FLYWHEEL WE HAVE WILL WORK IN THIS APPLICATION AND THE RING GEAR WILL BE IN CORRECT SPOT
IF YOU USE THIS PLATE  YOU MAY ALSO NEED TO ADDRESS SOME
FRAME RAIL LENGTH AND WIDTH ISSUES AT THE FRONT OF ENGINE !!

WE ALSO OFFER THE FRONT PLATE  TO FIT CORRECTLY INSIDE THE FRAME RAILS!!
ITS RARE AND HARD TO FIND ON THE USED MARKET,
BUT WE HAVE MADE THEM AVAILABLE
SEE OUR OTHER LISTINGS!!

These are made to fit the IH tractors AND THEY may well work on some models that are not listed.!!
Generally the cost of overhauling the old D310 and D-361 OR D-407 is what makes folks look at the re-powering with a MORE MODERN IH ENGINE
 GETTING THE POWER FROM THE DEPENDABLE 300 OR 400 SERIES ENGINE IS BY FAR THE LEAST EXPENSIVE ENGINE
UPGRADE AVAILABLE IF YOU WISH TO STAY WITH IH POWER

This is also a good way to replace the C263, 291 and 301 gas  found in the  IH tractors
HOWEVER!!
WE NEED TO KNOW IF YOU ARE REPLACING A GAS ENGINE AS THE ENGINE PLATE USED IS CUSTOM MADE
AND COSTS MORE $$$.  HOWEVER IT WILL PUT YOUR FRAME RAILS IN THE CORRECT SPOT AND ALLOW THE
SHEETMETAL TO FIT CORRECTLY!!

BE IT TRACTOR PULLING OR JUST MORE RELIABLE POWER;  THE IH ENGINE  HAS WHAT ARE YOU LOOKING FOR!
HERE IS A WELL MODIFIED PLATE AND NEW FLYWHEEL COMBINATION 


SEE OUR OTHER LISTINGS FOR INFO ABOUT OTHER UPGRADES FOR IH TRACTORS

717-464-2874